logo

Dimensional Inspection Services

Dimensional Inspection Services

Whether you have one difficult part to measure or a container load, General Tech Services can offer contract measurement services from our facility in Sharjah, UAE services further enhance the measurements provided from our calibration laboratory.

As there are many ways to establish product definition or to define design, there are even more ways to measure and inspect the actual product manufactured. Being fully aware of this, General Tech Services has amassed and developed an impressive array of state-of-the-art measuring instruments, equipment and technology. These technologies, coupled with our staff of highly skilled, trained, and experienced professionals, sustain a consistently high-quality yet cost-effective service unmatched in the industry. The end result for you is impartial, unbiased, and comprehensive information you can depend on

Our dimensional metrology inspectors are thoroughly trained to interpret customer prints and use CMM inspection services and technology for timely, reliable and repeatable dimensional inspection measurements. We use Mitutoyo's CMM for our measurement for products of sizes up to 900 X 1000 X 600 mm

We at GCLC perform dimensional inspection on surface and specialty features of machined parts and products, including internal and external fastener threads. First article inspection and third-party dimensional metrology services are performed according to NAS, MS and ANSI specifications. Our dimensional inspection and measurement capabilities are accredited to ISO/IEC 17025 by DAC (Dubai Accreditation Centre). All of the instrumentation used in the dimensional metrology lab is traceable to NIST (National Institute of Standards and Technology).

Our expansive, environmentally controlled, individual laboratories are aptly equipped to handle virtually any inspection need, big or small, with accuracies and measurement resolutions down to mere nanometers. Timely, easy-to-understand results can be provided in a variety of reporting formats including customer-specific formats.

Surface Finish Analysis

General Tech Services offers advanced surface finish analysis and surface mapping and metrology capabilities including graphical depictions, numerous sensor configurations, many algorithm and post-processing options, and even the raw surface finish data.

Non-Contact Inspection

© 2020 Copyright ® All Rights Reserved. General Tech Services LLC.